Clear View Defroster/Demister Stick Kits

Back to Catalog    Troubleshooting Guide    Frequently Asked Questions

Clear View Defroster Stick Kits

Stick Kits are defrosters for vehicles with existing defroster wiring and switching. These kits include only the items that stick to the glass including mounting foam, buss bars, heating elements, covers and instructions. Available the three sizes Stick Kits include the all components to apply a high quality cost  effective defroster.

Pre View the Frost Fighter Clear View Stick Kits (Adobe PDF).

To order see the product selector below

Clear View (CV) defrosters can be used to replace severely damaged defrosters that are not repairable using Frost Fighter repair kits. While Clear View kits need to be installed using the kits bus bars and tabs the vehicles existing wiring and switches can be used in most cases.

Can I scrape off the old defroster? Do I need to?
If your putting a Clear View kit into a vehicle that had a defroster the rear window will have the original grids on the glass.  Installing the Clear View kit requires that the glass be CLEAN so it is a good idea to remove the old grids. The vertical side bars can stay in place. Sometimes the old grid will come off with a razor blade and be gone and sometimes the old grid's conductor will come off but there will be a brownish red tint in the area of the lines and that's in the glass so it is not going anyplace.

Will the Clear View kit match my old defroster on my car?
Will the lines match up? It is not likely that the Clear View Defroster will match your existing vehicles defroster in spacing or layout. If tempted to remove grid lines the rule is that the number of grid lines and lay on the Buss Bars MUST be as shown in the instructions.

Please see the Clear View Frequently Asked Questions for a full rundown on the 2600 Series Stick Kits.  

EASY Clear View Size Guide and Selector

STEP 1 Determine Defroster Area There are three Clear View Electric Defroster Kits to choose from. Finding the right kit for your vehicle is easy, just follow the steps below. Take a good look at your vehicles rear window to establish the area for the Clear View defroster.
STEP 2 Measure the Glass Measure to the edges of the glass and select a Clear View Kit that is at least 1-3 inches (3-8 cm) smaller in vertical (up and down) height than the windows maximum.  The maximum is 60 inches and the minimum is 40 inches. The defroster is trimmed during installation.

STEP 3 - Select the Clear View Stick Kit
Select the Clear View Stick Kit that fits within the area measured in Step 2 using the chart below. Click Add to Cart when your ready to check out.

Need the complete Clear View Kit? See the 2600 Clear View Page

*Grids are trimmed to your vehicles window as part of the installation process.

Still have questions? Our customer service staff tracks the most Frequently Asked Clear View Questions along with a comprehensive Defroster Troubleshooting reference that can answer most questions.

For those really though defroster questions we have Dr. Defroster standing by to help. Contact Doc by email at the bottom of the Defroster Fix It page. 

Frost Fighter Products

See What Our Customers Say